How To Fill My Pool With Water

Download Article

Freshen upwards your pool water with this handy, in-depth guide

Download Article

Pond pool h2o can get bad over the years — so bad that chemicals lose their effectiveness. With this information and a free weekend, you (and a friend) can bleed and refill your pool without spending much more than $200 (non including necessary chemicals for new water).

1
Become to a dwelling house comeback store and rent a submersible sump pump. Sump pumps tin can be rented for about $36/24 hours. Do this early in the twenty-four hours so your pool is empty before dark.
- Your rental should include rubber burn down hoses in l feet (fifteen.2 m) lengths. Two should be enough for most homeowner, but cheque to brand sure the pool is non more than than 100 feet (thirty.5 thousand) from your clean out/sewer access point.
2
Set up the sump pump and discharge hoses, connecting the hoses to a clean out. This stride is very important. Most municipalities won't let y'all drain your h2o directly into the street or a neighbor'south yard, for example. That leaves you 2 options of where to drain the water:
- Direct into the clean out. This is normally a 3 to 4 inch (seven.six to 10.2 cm) plastic piping on your holding, usually outside a bathroom or the kitchen, with a screw cap on it which leads straight into the sewer. The metropolis will reuse this water. On older homes, one clean out ordinarily exists and is elevated on a wall. On newer homes, 2 clean outs usually exist, and they are basis-level — sometimes obscured past landscaping.
  - Using a clean connected to a wall is risky and could cause water harm to the house. If your clean out is connected direct to your house. Consult a puddle specialist or full general contractor before proceeding.
- Gargle the lawn, plants, or other shrubbery. This is non recommended if you are draining the entire puddle, nor is information technology a corking thought on sure lawns or plants that don't react well to excessive table salt or chlorine. Sure grasses and Oleander species tin have pool h2o, but citrus, hibiscus, or other salt-sensitive plants should not be irrigated in this fashion.
Advertisement
3

Lower the pump into the pool and plug it in. Brand sure the hose is properly attached and make sure the other end of the hose is stuck into the clean out before plugging in the pump. Some hoses will get down nigh 3 feet (0.9 m) into the make clean out before hit something; make sure to lodge it in properly.
4
Watch your h2o disappear, monitoring the discharge carefully. The time information technology takes to drain your pool water will depend on the municipality laws, the pump speed, and the total size of the pool.
- Although information technology may sound strange, check your municipality's laws concerning the discharge rate. In some municipalities, the belch rate is capped quite depression — Phoenix, for example, sets theirs at 12 gallons (45.4 L) per infinitesimal (or 720 gal/hour). This ensures condom disposal of the h2o into the sewer.
- Most good pumps will far exceed the municipality's maximum belch charge per unit. They'll function safely at 50 gallons/minute, and top out at about 70 gallons/minute.
- Your pool size will besides determine how long it takes. If you're pumping at 30 gallons/minute, or ane,800 gallons/hour, and you have a 25,000 gallon (94,635.3 L) pool, information technology will take roughly xiv hours to drain the pool.
5

Every human foot or so of water level decrease, spray the perimeter of the pool's previous water line with a hose. Practice this especially if your water is dirty, equally this will save yous time in the terminate. Endeavour some brushing while you are at it.
6

Wait as the pump removes well-nigh all of the water, draining the last chip manually. How much water the pump is able to remove will depending on your pool's contours at the deep end. Bleed the last pes or so manually with two buckets. This is where a helper comes in handy.

Advertizing

one

Blast debris out of the popular-ups with your hose. If you accept an in-floor cleaning system, this is a great selection for you to utilize. Alternately, you lot tin contact the manufacturer of the puddle for specific servicing/repair tips.
2
Clean abroad any calcium or calibration rings. Now is also a proficient time to make clean away calcium or calibration rings (if whatever exist). Calcium, Lime, and Rust remover, also known as CLR, usually works pretty well. Work at the tougher buildups with a putty knife, being careful not to damage the lining of the pool. Bottom buildups tin usually exist dispatched with safety gloves, a scrubbing pad, and the aforementioned CLR.
- To go along the rings from reappearing, you can buy some "stain and scale inhibitor." Check the manufacturer's instructions for applications, as well as for repetitions. Some inhibitors need to be reapplied every month to be effective.
3

Perform an acid wash on your puddle (optional). A expert acrid wash will clean the walls of your pool, go on the water looking bright and transparent, and make the whole shebang an altogether more than pleasant experience. If your pool is already fairly clean or y'all don't have time, you may skip this pace.

Advertizement

ane

Approximate the amount of time it will accept to fill up the pool with your current pumps. You don't desire to go to sleep and wake up with a lake in your backyard. Do a piffling flake of homework to avert needing to damage-control in the cease.
2
Fill up upwardly your pool. Connect 1 or more than garden hoses to available spigots and drop them into the side of the pool. Turn them on. If your pool was newly plastered for example, you lot probably want to tie on some socks to the spout of the hose and secure with a couple rubber bands. That way, the force of the water doesn't mess with the plaster.
- Water should not be expensive. If you demand to, call your city and ask almost how much they charge.
three

Wait for the water to settle a few hours before adding any chemicals or additives. You're near there. All yous need to practise at present is exam the alkalinity of the water, pH, and calcium hardness. After you've performed these tests, adjust the alkalinity, pH, and hardness of the water appropriately earlier adding chlorine, CYA (Cyanuric Acid), or table salt.

Add together New Question

Question

Do I need to add chemicals to a fresh pool?

Yes, you must add chemicals to keep the h2o make clean.
Question

How often should I bleed my in-ground pool?

I bleed and refill my indoor pool every other twelvemonth. I also use it as a opportunity to patch up the tile grout and make other repairs.
Question

Practise I need to drain my 20,000-gallon pool all the way to have it measured for a new liner?

Try to measure it with a thou stick by sticking information technology down against the inside of the pool (equally shown in the pic.) The length could be measured above the pool, along the walkway beside the pool edge. Width is the same if measured at the backside of the pool along the edge.
Question

Do I need to add together chemicals to a freshly filled puddle?

Aye. I would shock the pool with 1 lb. of chlorine shock per 5000 gallons. Then, install your chlorine applicator (liquid or solid). Look 24 hours with the pump circulating. Then, test the pH and chlorine content. I would also take a sample to a puddle shop for a complete assay.
Question

Is it safe to swim in a pool while it is being drained with a sump pump?

No, you should not swim while it is being drained.
Question

Should I bleed the pool in the heat of summer, or await until fall or winter in California?

Yous can wait until it begins to absurd down, such as autumn time or commencement of winter. Endeavour non to exercise information technology while information technology'due south besides common cold for your own health.
Question

Volition an empty pool pop out of the ground?

The swimming pool will not pop-upwardly out of the basis because the pool was put in the ground when installed. The only mode the pool can come up out the ground merely if you remove it out of the groud.
Question

Can I drain pool water in the street

Yes, but locate the hose in the gutter or the tempest drains and non across the street with traffic.
Question

Should I bypass the water softener when filling pool?

Yes. Your h2o softener system nigh likely uses salt pellets. The salt can alter your chlorine levels and make your readings inaccurate, plus it would be a waste of expensive conditioning salt.
Question

Practise I have to remove the hydrostatic relief valves from the bottom of the pool when I am draining it to prevent it from popping out of the ground?

Especially on a concrete pool, you must open the hydrostatic valve every bit shortly as yous can become to it in guild to brand certain that underground h2o can get into the puddle to release the pressure from beneath. Some pools accept a dissever pipage leading to the ground pit under the pool to allow you to drain the water out using a utility pump. In that case, you may not need a hydrostatic valve.

Encounter more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Advertising

Video

You shouldn't have to practice this more than once every three-v years I'm told. Unless you take a lousy pool guy and/or like the do.
Y'all should not empty your pool in extreme heat, I'thou told.
Don't forget to render your equipment to Home Depot.

Thanks for submitting a tip for review!

Don't forget to switch off circuit breakers to the pump and other equipments.
Not a practiced idea to bleed your pool if can cause damage to your pool and cause "popular-off" that will cost more than. Telephone call an underwater puddle repair company if you need to do repairs to your puddle.
Be careful with electricity around h2o. Specially when using a metal pole.

Advertising

Things You'll Need

Submersible sump pump with hoses to reach sewer line.
Garden hose
Patience

Nigh This Article

Article Summary X

To drain and refill your swimming puddle, start by renting a submersible sump pump from a dwelling house improvement shop, if you don't already accept one. And so, you should connect the clean out pipe from the sump pump to the sewer, if your municipality allows that corporeality of drainage, or direct the h2o to irrigate your plants. After the pool is drained with the sump pump, clean the puddle with a hose and scrub brush. Finally, refill the pool using 1 or 2 hoses and wait for the water to settle before adding chemicals. To learn how to make clean your puddle using an acid wash, read on!

Did this summary aid you?

Cheers to all authors for creating a page that has been read 670,587 times.